Share
Pin
Tweet
Send
Share
Send
To do this, we need a fishing line, beads, ribbon (satin or organza), a needle, scissors, a lighter or a candle. We select a tape of such a width that it coincides with the diameter of the beads. The needle should be with a narrow eye. Instead of fishing line, you can use a thread by the color of the tape.
We wind off a fishing line 20 cm long. We don’t need the entire length, it is necessary for the convenience of stringing beads and ribbons. We will sell the fishing line into the eye of the needle and tie a double knot at only one end.
Take a tape 50 cm long. Retreating from the free end of 15 cm, we pierce the tape from below with a needle.
Next, we make two stitches with an ordinary seam (1, 5 cm each). The length of the stitch depends on the diameter of the beads that we select for our bracelet.
We string the bead on the fishing line and pierce the tape with the needle down perpendicular to the extreme point of the bead.
Having retreated 1, 5 cm, we bring the needle to the top and again we string the bead. Thus we string another 8 beads.
In the end, as in the beginning, we make two simple stitches without beads.
Holding the knot at the beginning, we tighten the beads to each other. We straighten the resulting accordion with our fingers.
When the desired effect is achieved, we tie a fishing line on a double knot at the end and cut off the excess end.
It is necessary to hide the knots from the fishing line, so in their place we tie knots from the tape on both sides. Do not tighten too tight. It is necessary to preserve the visual lightness of the bracelet and such nodes are needed to hide small flaws.
Cut the edges of the tape at an oblique angle and singe them with a lighter, barely touching the fire.
As a result, we got an original bracelet, which we made with our own hands.
Share
Pin
Tweet
Send
Share
Send
