PINK BOW WITH BEADS

Send

When a baby appears in the family, I want him to be the most beautiful and cheerful child. You can, of course, go shopping for exclusive items, but I prefer to do them myself. Thus, such a cute bow for a princess was born. To make it, it took me very few nerves, a couple of hours of time and these materials:

satin ribbon 2.5 cm wide .;
scissors;
ruler;
pencil;
beads;
glue gun;
hairpin base;
two circles of skin.

First of all, we need to cut the tape into segments 11cm long. Such pieces we need about 60 pieces.

Let's start creating. The segment must be folded in half, with the front side inward.

On a bend, preferably in the center, drop a drop of glue and squeeze well.

When the glue is a little dried up, fold the edges in half again, also face inward.

Now they need to be combined with each other so that they are layered.

We singe the ends with fire, thereby glue all the edges together. If everything was done correctly, the crown should get this look.

Then, to the place where the tape stuck together, glue the bead.

We perform this procedure with all segments of the tape. When all the blanks are prepared, we begin to collect the bow. For this I use skin.

We begin to stick from the outer edge of the circle to the center.

I decided to stick to the beautiful side, because another such circle will be used, which will hide all the shortcomings of the wrong side. The second and subsequent rows are best glued in a checkerboard pattern, relative to the previous one, then the bow will be more magnificent.

When it came time to make the middle, I just poured a lot of glue into it and put blanks into it.

The bow is ready, it remains only to fix it on the basis for the hairpin. For this, I decided to use a second piece of skin of the same size. In it, having previously measured out the hairpin, we make two cuts, drag the edges of the hairpin and glue to the first piece of leather with a bow.